Skip to content

Menu

  • Home
  • Le Blog

Archives

  • juin 2024
  • mars 2020
  • avril 2019
  • février 2019

Calendar

juillet 2025
L M M J V S D
 123456
78910111213
14151617181920
21222324252627
28293031  
« Juin    

Catégories

  • Blog
  • Blog-En
  • Non classé

Copyright GEH-TECH 2025 | Theme by ThemeinProgress | Proudly powered by WordPress

GEH-TECHMake system simple
  • Home
  • Le Blog
Written by gehrhardt19 avril 2019

Mic to line amplifier

Blog-En Article

Introduction

So I needed to connect a standard microphone to a conventional speaker amplifier. The signal comming out the mic is really low. It can be lower than 20mV. You need to amplify the signal to the line level. That’s why with the component I have in stock I do this simple microphone pre-amplifier.

The schematic

Let’s see the schema:

Lire la suiteGetting DMX data in a PIC

The Principle

Input stage

The input has a LC filter to avoid HF noise and a coupling cap. Take care on the resonant frequency of L1 and C1. To avoid high Q factor you can add a 100R in series with L1. I measured the peak at 4.8MHz witch is not a noisy frequency.

Lire la suiteMarantz PM350 : How to repair a vintage amp

The input is a jack connection with an asymetric convertion. With this you can use a balanced and unbalanced microphone and XLR to JACK converter are also supported.

Amplification stage

First I wanted to use an instrument amplifier. But the bandwidth is really low if you need gain. So I use a standard opamp. The amplification is really basic. On the negative input there is a RC filter to rejects the low frequencies. For this application I used the TL081 OpAmp. Other can also be used as the LT1055 for example.

Lire la suiteIsolated DMX splitter

With a standard microphone you will need +40dB gain. The potentiometer R3 is used to adjust the gain. I put a 5k multitour potentiometer and it is set at mid-range.

Output stage

The output has also a dc-link with a 1µF cap. Than it’s connected to RCA connector.

Power Supply

The power supply comes from an 9V AC adapter. I used this to have a symetrical power supply for the opAmp. To do this, only two diodes, one to push positive voltage and one to tied negative voltage.

 Simulation results

The frequency response simulated with LT-spice is :

The response is really flat over the audio frequencies. Maybe It could be good to filter more frequencies under 10Hz by reducing C3 to 10µF. Otherwise seems OK.

Manufacturing

I have also an old small box. Drilling some holes and the power connector is fixed with glue. for the PCB i used a prototype board. The result is :

External link

Different designs are available on sonolec-musique.com[:]

Tags: Audio, DIY, Electronic

Archives

  • juin 2024
  • mars 2020
  • avril 2019
  • février 2019

Calendar

juillet 2025
L M M J V S D
 123456
78910111213
14151617181920
21222324252627
28293031  
« Juin    

Catégories

  • Blog
  • Blog-En
  • Non classé

Archives

  • juin 2024
  • mars 2020
  • avril 2019
  • février 2019

Catégories

  • Blog
  • Blog-En
  • Non classé

Copyright GEH-TECH 2025 | Theme by ThemeinProgress | Proudly powered by WordPress