Introduction When you need to connect DMX projectors you can use wireless or cable. In my case, I have a fixed setup so I use a wire solution. But the problem with DMX is the low immunity regarding disturbances. When a connexion is lost in the chain all the projectors after the losy connection...
Continue reading
Introduction A guy bring to me a MARANTZ PM350 amplifier. He says that to have a little sound the volume button has to be set to the maximum. And, it only works on left channel. The PM350 is a vintage (1980) audio amplifier designed by MARANTZ. I used it several years and the sound...
Continue reading
Introduction So I needed to connect a standard microphone to a conventional speaker amplifier. The signal comming out the mic is really low. It can be lower than 20mV. You need to amplify the signal to the line level. That’s why with the component I have in stock I do this simple microphone pre-amplifier....
Continue reading
Need english version ? it’s here Introduction Lorsque je modifie les fonctions d’un projecteur, j’utilise le bus DMX pour le piloter. Cet article vous présente le code en C que j’utilise pour décoder les données. Il est utilisé sur des microcontrolleur PIC de chez Microchip mais il est adaptable à d’autre hardware. Présentation du...
Continue reading